The UART handleInterrupt handler unconditionally read RDR on every
interrupt without checking which flag triggered it. On newer STM32
USART peripherals (U5, L4, L5, L0, G0, F7, WL), RXNEIE enables
interrupts for both RXFNE (data ready) and ORE (overrun error).
Unlike older families (F1, F4), ORE is not cleared by reading the
data register, it must be explicitly cleared via the ICR register.
When an overrun occurred (e.g. serial data arriving while ADC
busy-waits in Get()), ORE would trigger the interrupt, the handler
would fire without clearing it, and the interrupt would re-trigger
immediately, causing an infinite interrupt storm that locks up the
CPU.
Fix by:
- Checking RXFNE/RXNE (bit 5) before reading data from RDR
- Clearing ORE (bit 3) via ICR on newer peripherals when set
- Adding errClearReg field to UART struct, set to &Bus.ICR in
setRegisters() for all ICR-capable families
- Preserving the SR+DR clearing sequence for older F1/F4 families
Signed-off-by: deadprogram <ron@hybridgroup.com>
Add processor target (cortex-m33), linker script (2048K flash, 768K RAM),
and arduino-uno-q board target. Runtime initializes 160MHz clock via PLL1
from HSI16, with PWR Range 1 and EPOD booster.
Also add psctype abstraction for timer PSC register width, needed because
the U5 SVD defines PSC as a 16-bit register.
* Add STM32G0B1 target support
Introduce support for STM32G0B1 microcontrollers, including target-specific JSON files, linker scripts, and runtime initialization. This update adds hardware support for GPIO, UART, SPI, I2C, timers, and additional board-specific configurations like Nucleo-G0B1RE.
* Update STM32G0 clock initialization to 64MHz and adjust related configurations
Reconfigure STM32G0 to use a 64MHz system clock via PLL with HSI16 as the source. Update flash latency, prescaler settings, and I2C timing values to reflect the new frequency.
* Cleanup
* Cleanup
* Add STM32G0-specific UART implementation
Introduce a new UART implementation for the STM32G0 series with chip-specific setup and configuration methods. Update the generic STM32 UART code to exclude STM32G0.
* Refactor STM32G0 runtime and machine code to utilize chip-specific register access functions
Simplify and standardize register operations with dedicated setter methods in the STM32G0 runtime and machine code and cleanup redundant syntax.
* Remove redundant commented-out APBENR1 register operations in STM32G0 machine code
* Introduce FDCAN support for STM32G0B1 series
Add FDCAN peripheral implementation targeting STM32G0B1, including support for standard, extended identifiers, and bit rate configuration. Update board files to include FDCAN pins, instances, and clock configuration for Nucleo-G0B1RE and Amken Trio boards.
deadprogram
Michael Teichgräber
Amken USA