This updates lib/cmsis-svd, pulling in the updates to the Espressif SVD
files here:
https://github.com/cmsis-svd/cmsis-svd-data/pull/3
This is needed for wifi/BLE support on the ESP32-C3 (the older SVD files
were missing some necessary interrupts).
We have an optimization for this specific pattern, but it's really just
a hack. With the addition of unsafe.Add in Go 1.17 we can directly
specify the intent instead and eventually remove this special case.
The code is also easier to read.
Do it all at once in preparation for Go 1.18 support.
To make this commit, I've simply modified the `fmt-check` Makefile
target to rewrite files instead of listing the differences. So this is a
fully mechanical change, it should not have introduced any errors.
In the early days of TinyGo, the idea of `postinit` was to enable
interrupts only after initializers have run. Which kind of makes
sense... except that `time.Sleep` is allowed in init code and
`time.Sleep` requires interrupts to be enabled. Therefore, interrupts
must be enabled while initializers are being run.
This commit simply moves the enabling of interrupts to a point right
before running package initializers. It also removes `runtime.postinit`,
which is not necessary anymore (and was only used on AVR).
There were a few issues that were causing qemu-system-arm and
qemu-system-riscv to give the wrong exit codes. They are in fact capable
of exiting with 0 or 1 signalled from the running application, but this
functionality wasn't used. This commit changes this in the following
ways:
* It fixes SemiHosting codes, which were incorrectly written in
decimal while they should have been written in hexadecimal (oops!).
* It modifies all the baremetal main functions (aka reset handlers) to
exit with `exit(0)` instead of `abort()`.
* It changes `syscall.Exit` to call `exit(code)` instead of `abort()`
on baremetal targets.
* It adds these new exit functions where necessary, implemented in a
way that signals the correct exit status if running under QEMU.
All in all, this means that `tinygo test` doesn't have to look at the
output of a test to determine the outcome. It can simply look at the
exit code.
This change adds support for the ESP32-C3, a new chip from Espressif. It
is a RISC-V core so porting was comparatively easy.
Most peripherals are shared with the (original) ESP32 chip, but with
subtle differences. Also, the SVD file I've used gives some
peripherals/registers a different name which makes sharing code harder.
Eventually, when an official SVD file for the ESP32 is released, I
expect that a lot of code can be shared between the two chips.
More information: https://www.espressif.com/en/products/socs/esp32-c3
TODO:
- stack scheduler
- interrupts
- most peripherals (SPI, I2C, PWM, etc)
Ayke van Laethem
deadprogram
Yurii Soldak
sago35